Specifications

• Technical

  ---

  Part Number(s)

  714259-000

  Technology

  intellitouch

  Number of Touches

  1

  Input Methods

  Finger
  Gloved hand
  Passive stylus

  Dimensions

  2.36" x 3.51" x 0.61" / 59.94 mm x 89.03 mm x 15.44 mm

  Interface

  USB (Full Speed)
  Plug and play compatible

  Surface Treatment

  clear

  Resolution

  Approximately 4096x4096, size independent, 255 levels of Z (pressure)

  Conversion Time

  Approximately 10.4 ms per coordinate set.

  Input Voltage

  +4.75 to +5.25 VDC

  Power Input

  +5 VDC, nominal (+4.75 to +5.25 VDC)

  Reliability

  MTBF greater than 345,000 hours per MIL-HDBK-217-F2 using the parts stress calculation method for the ground benign environment with an ambient temperature of 25°C

  Construction

  Four-layer surface-mount design with internal ground plane for EMI suppression

  Flammability

  The printed circuit board substrate is rated 94V0. All plastic components, such a headers and connectors, are also rated 94V0.

  Shock and Vibration

  Three axis sine wave, 50Hz to 2kHz, 1G, 2 minutes/Octave with dwell on resonance

  ESD

  Per EN 6100-4-2 1995: Level 4. Contact discharge 8kV, air discharge 15kV.

  Operating Temperature

  0°C to 65°C

  Operating Environment

  IntelliTouch SmartSet protocol
  Initial/Stream/ Untouch/ Z-axis Enable Modes

  Storage Temperature

  -25°C to 85°C

  Humidity

  Operating: 10% to 90% RH, noncondensing
  Storage: 10% to 90% RH, noncondensing

  Altitude

  10,000 feet

  MTBF

  30,000 hours demonstrated

  Mounting Options

  All mounting holes are plated through-holes for chassis ground connection. Refer to the drawings at the end of this document.

  Connectors and Pin Definitions

  The connector configuration permits the controller to be placed in-line between the touchscreen and a USB hub or host attachment.

  Controller Cables

  Contact Elo for more information.